From transducer to turnkey system, an answer for each need

" ULTRASOUND GENERATOR " Board : Emission, Reception, Digitalization

Provided with drivers : DLL 32 bit, Labview, VisualC++

  Pulser - Receiver Board

 
These boards take in charge pulsing and receiving functions needed for ultrasonic applications:
  -   Narrow pulse up to 400V,
  -   Receiver with adjustable gain up to 80 dB with selectable filters, Distance Amplitiude Correction and AGC
      (linear or arbitrary DAC) 

IPR-AD 1210 Board
    Bandwidth 0,3 MHz to 30 MHz
    Pulser 400 V
    Digitizer100 MHz, 12 bit
   Processing  DSP / FPGA
   PCI Bus
   Long board
 

 AD-81G-PCI  8bit 1GHz 
       Converter board for high frequencies
       Bandwidth DC to 350 MHz
     Format ¾, on PCI bus.

Applications : Small thickness and thin coating measurements  Bond analysis, Micro-electronics or  acoustic microscope  applications.
 

  AD 1210-PCI Board
    High resolution in conventional frequencies
    12 bit  100MHz


 

The SMC-4/8-PCI is a high performance, stepper motor board. The board provides a complete (4 or up to 8 axis) motion control solution. The stepper motor controller board is an improvement of the SMC4 board with better accuracy in positioning, high-speed position readout for each axis. Some of the improvements are the ability to select an acceleration and deceleration profile independently for each axis. Several modes are available: trapezoidal mode, S-Curve or custom design acceleration and deceleration rate. The maximum number of pulses can reach 500Kpps, which gives the board the possibility for micro stepping.

The board also provides encoder inputs to be able to use a feedback position (close-loop) during the motion in order to improve position and to reduce backlash in the system. All of these improvements give a smoother and a higher resolution to the motion.

In addition versatile connections are available.  The basic offer consists of the following:

The SMC4-PCI (4 channels) is fully compatible with
     the SMC4 board.

The SMC8-PCI can drive independently up to 8 axis.

As a result, the SMC-4/8-PCI board has many potential uses in engineering, scientific research and development, manufacturing, and robotics. The instantaneous position information feedback makes the SMC-4/8-PCI an ideal scanner control for Ultrasonic imaging, or other applications where accessing the immediate positional information is critical. The SMC-4/8-PCI can control most stepping motors, regardless of their size, power, and speed.

  Ultrasound Generator

                                                    Low and conventional frequencies

ARB-1410 Board

     Programmable waveform generator, on PCI bus:

    It provides:
   Waveform : sine, square, amplitude and frequency
      modulated, Acoustic Emission type (burst), arbitrary
  
      14 bit  D/A converter, 100 MHz with analog output
         +/-20V up to 15 MHz or +/-35V à 2MHz or 150V
      up to 0,7 MHz
    
 Applications : Research in Acoustic Emission, acousto-ultrasonics, waves analysis…


                                                    Very high frequencies

External module PR60
       External pulser receiver remotly controlled
       Bandwidth 50 MHz
       Emission 475V
       Drived by ULTRAWIN software



ER1 Module
     UT analog pulser receiver system
     Narrow PULSE - Adadapted and amplified RECEIVER
      RF signal  output 15 MHz.
     '' Echo '' and/or transmission mode
   
Applications : Remote controlled pulser/ receiver with long distance transmission, student exercise, ...